TEC B-670 Series Maintenance Manual page 24

3. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
5) Connect the harness S (yellow) to the CN 2 on the stabilizer PC board ass'y and the harness P (black)
to the CN 3, respectively. Respectively connect the red and the yellow cables detached in the step
2 to the CN 4 and the CN 5 on the stabilizer PC board ass'y.
CN 2:Harness S(Yellow)
CN 3:Harness P (Black)
NOTES: 1. The connector design prevents wrong insertion. Therefore, when you connect the
connectors, care must be taken to the connector faces and avoid forcibly pressing the
connectors.
2. After you connect the connectors, check that no looseness exists on them.
6) Secure the left side cover using the six screws, then close the top cover. Stick the attached EU
standard sticker on the sticker currently stuck.
NOTE: Care must be taken to the cables when attaching the left side cover.
CN 4:Red cable
CN 5:Yellow cable
Harness S (Yellow)
CN2
CN5
CN4
CN3
Harness P (Black)
Yellow Cable
Red Cable
ROM Version Sticker
Model Name Sticker
EU Stundard Sticker
3-8
EM18-33017
(Revision Date: Jul. 26 '99)
3.4 STABILIZER KIT
Fig. 3-12
Fig. 3-13