TEC B-670 Series Maintenance Manual page 23

3. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
3) Connect the harness S (yellow) to the CN 9 on the CPU PC board and the harness P (black) to the
CN 17, respectively.
NOTE: As for the harness, connect the connector housing which has fewer pins to the connector on
the CPU PC board side.
4) Remove the screw A, then insert the guide plate provided to the stabilizer PC board ass'y into the
square hole of the part B. Secure the stabilizer PC board ass'y using the screw A.
Guide Plate
CN9
CN17
Guide Plate
Square Hole
Part B
Harness S (Yellow)
Harness P (Black)
Stabilizer PC Board Ass'y
Stepping Motor
3-7
(Revision Date: Jul. 26 '99)
3.4 STABILIZER KIT
Fig. 3-10
Screw A
Fig. 3-11
EM18-33017