TEC B-670 Series Maintenance Manual page 32

6. DIAG. TEST OPERATION
6.2 SELF TEST MODE
In self test mode the printer status is printed in two types of sample print. The result of the head broken
element check is indicated in the display.
6.2.1 Maintenance Counter Printing
The data from 1 to 31 on a sample print is printed. This data is the printer status and the value set
in the parameter setting mode.
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
< 1 > D I A G N O S T I C
R I B B O N
Select the ribbon type from those
at the right by pressing the
[FEED] key or [RESTART] key.
M A I N T E N A N C E
C H E C K I N G
The result of the self test
is printed. After printing,
the initial display will be
shown.
NOTES: 1. If the maintenance counter printing results in an error, the printer will display the
2. Both label and tag paper can be used for printing.
Power off
Press the [PAUSE] key.
T R A N S M I S S I V E
Press the [PAUSE] key.
C O U N T E R
Press the [PAUSE] key.
& P R I N T I N G
error message and stop printing. The error status can be cleared by the [PAUSE]
key, however, the display will return to the initial display "<1> DIAGNOSTIC
V1.0A". Printing is not automatically resumed after the error is cleared.
Press the [PAUSE] key.
V 1 . O A
Continued on Section 6.2.2
Automatic Diagnostics Printing.
NO RIBBON (No ribbon : Thermal direct)
TRANSMISSIVE
(Transmissive ribbon : Thermal transfer)
NO TRANS.
(Non-transmissive ribbon : Thermal transfer)
The printer is checking or printing
the status
6-3
EM18-33017
(Revision Date: Jan. 14 '99)
6.2 SELF TEST MODE