TEC B-670 Series Maintenance Manual page 71

6. DIAG. TEST OPERATION
Press the [PAUSE] key. (See NOTE 3.)
Set the print speed
P R
Press the [PAUSE] key. (See NOTE 3.)
Set the sensor type
S E
Press the [PAUSE] key. (See NOTE 3.)
Set the ribbon type
R I
Press the [PAUSE] key. (See NOTE 3.)
From of the preceding page.
B
Set the print count from those at the
right by pressing the [FEED] key or
[RESTART] key. (See NOTE 2.)
I N T S P E E D
Select the print speed from those at
the right by pressing the [FEED]
key or [RESTART] key.
N S O R T R A N S M I S S I V E
Select the sensor type from
those at the right by pressing
the [FEED] key or [RESTART]
key. (See NOTE 2 and 4.)
B B O N T R A N S M I S S I V E
Select the ribbon type from
those at the right by pressing
the [FEED] key or [RESTART]
key. (See NOTE 2, 5 and 9.)
To be continued on
of the next page.
B
5000 (Print count 5000)
1000 (Print count 1000)
500
100
50
10
5
3
1
4 i n c h / s
3 inch/sec.
4 inch/sec.
8 inch/sec.
NONE
(consecutive form)
REFLECTIVE
(black mark sensor)
TRANSMISSIVE
(feed gap sensor)
NO RIBBON
(No ribbon: Thermal direct)
TRANSMISSIVE
(Transmissive ribbon:
Thermal transfer)
NO TRANS.
(Non-transmissive ribbon:
Thermal transfer)
6-42
6.4 TEST PRINT MODE
(Print count 500)
Press the [FEED] key
(Print count 100)
(Print count 50) and [RESTART] key
(Print count 10)
at the same time.
(Print count 5)
(Print count 3)
(Print count 1)
To
preceding page.
Press the [FEED] key
and [RESTART] key
at the same time.
To
preceding page.
Press the [FEED] key
and [RESTART] key
at the same time.
To
preceding page.
Press the [FEED] key and
[RESTART] key at the same
time.
To of the preceding page.
C
EM18-33017
of the
C
of the
C
of the
C