TEC B-670 Series Maintenance Manual page 73

6. DIAG. TEST OPERATION
From of the
A
preceding page.
NOTES: 1. When there is no change to the print condition, select one of the test print options
2. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds
3. A selected print condition is activated when the [PAUSE] key is pressed.
4. When the feed gap sensor is selected, the gap between labels becomes 3mm long.
5. Non-transmissive (NON TRANS.) ribbon cannot be used so the ribbon type must
6. A label size greater than the image buffer length cannot be designated. The image
From of the preceding page.
B
Press the [PAUSE] key.
Select the test print from
those at the right by
pressing the [FEED] key
or [RESTART] key.
A designated number of
test prints are issued when
pressing the [PAUSE] key.
(See NOTE 8.)
Press the [PAUSE] key.
to issue the test print.
enables a fast forward.
be set to transmissive (TRANS.) ribbon or no ribbon.
buffer length differs according to memory size. If designated, the printer prints in
the image buffer, or the printer stops because of an error.
SLANT LINE (1 DOT)
SLANT LINE (3 DOT)
CHARACTERS
BAR CODE
NON-PRINTING
FACTORY TEST PATTERN
AUTO PRINT (TRANS.) :
Process test print/Transmissive sensor
AUTO PRINT (REFLECT.) :
Process test print/Reflective sensor
6-44
EM18-33017
(Revision Date: Jul. 23, 2002)
6.4 TEST PRINT MODE
Press the [FEED] key
and [RESTART] key at
the same time.