TEC B-670 Series Maintenance Manual page 55

6. DIAG. TEST OPERATION
6.3.7 Font Zero Selection
< 1 >
< 2 >
Press the [PAUSE] key eight times.
Z E R
NOTES: 1. Holding the [FEED] key or [RESTART] key down for more than 0.5 seconds
2. A changed zero font is stored in memory by pressing the [PAUSE] key.
Power off
Turn on the power while
holding down the [FEED]
key and [PAUSE] key.
D I A G N O S T I C
Press the [FEED] key.
P A R A M E T E R
O F O N T
Select either zero font with the
[FEED] key or [RESTART]
key. (See NOTE 1.)
Press the [FEED] key
and [RESTART] key
at the same time.
enables a fast forward.
V 1 . O A
S E T
0
Press the [PAUSE] key .
Continued on Section 6.3.8
Control code selection
6-26
6.3 PARAMETER SETTING MODE
• 0 (without slash)
• ø (with slash)
EM18-33017