Inlet / Drain Led Flashes And Lights Up Alternately (Fully Integrated); Dishwasher Program Can Be Selected But Not Started; Dishwashing Program Interrupted, No Fault Indication - Miele G1000 Technical Information

G1000 / G2000 Dishwashers
6.8.4 Inlet / Drain LED Flashes and Lights up Alternately
(Fully Integrated)
On-site water supply valve closed.
a. Open water supply valve.
1. Check Filter in WPS (WaterProof System) for blockage.
a. Disconnect the dishwasher from the power supply.
b. Close the water supply valve.
c. Unscrew the WaterProof System from the water supply valve.
d. Remover the washer from the threaded union.
e. Remove the filter with needle nose pliers.
f.
6.8.5

Dishwasher Program Can Be Selected But Not Started

After switch-on, display is normal and LEDs light up/flash as usual. When a
dishwashing program is selected, it cannot be started.
1. Incorrect positioning of adjustable door lock latch.
a. Adjust the locking plate (5.2.9).
2. Door seal incorrectly seated.
a. Check the door seating and adjust as necessary (5.3.1).
6.8.6

Dishwashing program interrupted, no fault indication

Selected dishwashing program interrupted suddenly because door contact switch is
no longer closed, No fault is displayed and no fault is registered in the fault code
memory.
1. Incorrect positioning of adjustable door lock latch.
a. Adjust the locking plate (5.2.9).
2. Door seal incorrectly seated.
a. Check the door seating and adjust as necessary (5.3.1).
Clean or exchange the filter as necessary.
205
Technical Information