G2020 - Service Mode - Miele G1000 Technical Information

Technical Information
*1 If the dishwasher is hooked up to an external softener system, which operates
on the ion exchange principle (meaning salt reactivation), the water hardness
supplied by that system has to be set. If this value is not known, set to 10 gr/gal.
*2 If the electronic unit is replaced during service work, it must be programmed as
follows: First set the country version and model
dishwasher off. Repeat the accessing
then set the on-site water
*3 The version Southern Europe covers the following countries: Portugal,
France, The Netherlands, Belgium and Great Britain.
Save and Quit
Switch off the unit.
6.2.1.2

G2020 - Service Mode

Accessing
1. Press and hold the Start/Stop button.
2. Switch on the machine.
3. Release the Start/Stop button.
4. Immediately press and release the Start/Stop button 3 times and at
time hold it until the Start/Stop LED flashes.
5. Release the Start/Stop button
If the Start/Stop LED has not started to flash within approx. 4 sec., the accessing
procedure must be repeated.
Acknowledgement indicator
Successful accessing of the Service mode is indicated by a slow flashing Start/Stop
LED (1 Hz).
Options
Refer to Tables: 6-6 through 6-7.
G1000 / G2000 Dishwashers
procedure and set the machine height,
hardness.
112
version, then switch the
the 3rd