Table of Contents
Advertisement
Display
"REMOVE DOCUMENT"
"RX MEMORY FULL"
"SCANNER POSITION ERROR"
"SELF CALIBRATION"
"TRANSMIT ERROR"
"TONER CARTRIDGE NOT
INSTALLED"
"TRAY #2 LEFT COVER
OPEN"
"WASTE TONER FULL"
b
"CHANGE SUPPLIES"
"WASTE TONER NOT
INSTALLED"
"WASTE TONER REPLACE"
b
"CHANGE SUPPLIES"
Cause & Solution
L The document is jammed. Remove the jammed document (page 102).
L Attempted to send or copy a document longer than 600 mm using the
automatic document feeder. Press {Stop} to remove the document. Divide
the document into two or more sheets and try again.
L The memory is full of received documents due to a lack of recording paper
or a recording paper jam. Install paper (page 16) or remove the jammed
paper (page 97).
L If feature #442 (page 69) is set to "ALWAYS",
– check the connection between the computer and the unit.
– check the computer is turned ON.
L There is something wrong with the scanner position. Turn the power switch
OFF, then ON. If the problem cannot be solved, contact our service
personnel.
L The unit is changing the color calibration. Wait for a while.
L A transmission error occurred. Try again.
L The toner cartridge is not installed. Install it (page 11).
L The left cover of the optional input tray is open. Close it.
L The waste toner cartridge life is near its end. Replace the waste toner
cartridge as soon as possible.
L The waste toner cartridge is not installed. Install it (page 10, 108).
L The waste toner cartridge life is finished. Replace the waste toner cartridge
immediately (page 10, 108).
11. Help
87
Advertisement
Table of Contents
