Table of Contents
Advertisement
L Make sure that the recording paper guides (6)
are at the paper size mark and the recording
paper is under the paper limit mark (7). The
paper should not be loaded over the tab (8).
6
5
Insert the standard input tray to the unit, lifting the
front part of the tray. Then push it completely into the
unit.
Note:
L If the paper is not loaded correctly, re-adjust the
paper guides, or the paper may jam.
L If the standard input tray does not close, the plate in
the standard input tray may be lifted. Push the paper
and make sure that the paper is laid flat in the
standard input tray.
7
6
8
1. Introduction and Installation
Caution for the standard input tray
L Do not drop the standard input tray.
L Hold the standard input tray with both hands
when removing or installing. The standard input
tray weighs approximately 2.9 kg when the
recording paper is fully installed.
Do not touch the plate (1) on the left side of the
standard input tray.
1
Approx. 2.9 kg
17
Advertisement
Table of Contents
