Table of Contents
Advertisement
Feature/Code
Sending a fax at a specific
time
{#}{4}{1}{2}
Setting the Error Correction
Mode (ECM)
{#}{4}{1}{3}
Setting the connecting tone
{#}{4}{1}{6}
Setting the maximum fax
speed
{#}{4}{1}{8}
Selection
This feature allows you to take advantage of low-cost calling hours offered by
your telephone company. This feature can be set up to 24 hours in advance of
the desired time.
{0} "OFF" (default)
{1} "ON"
To send a document:
1. If the {Fax} light is OFF, turn it ON by pressing {Fax}.
2. Set the original (page 22).
3. If necessary, change to the desired resolution (page 48) and the desired
contrast (page 48).
4. {Menu} i {#}{4}{1}{2}
5. Press {1} to select "ON". i {Set}
6. Enter the fax number.
L To enter an item using one-touch dial feature and navigator directory,
see step 3 on "7.2.1 Using the scanner glass", page 49. (When using
navigator directory, you do not have to press {Directory} before
pressing {V} or {^}.)
7. {Set}
8. Enter the transmission start time.
L If you selected 12-hour time entry (page 25), press {*} repeatedly to
select AM or PM.
L If you selected 24-hour time entry (page 25), the time is set using 24-
hour time entry.
9. When using the scanner glass, press {Set}. i {Black}
When using the automatic document feeder, press {Set}.
L The document will be fed into the unit and scanned into memory. The
unit will then send the data at the specified time. You cannot use this
feature for another fax transmission until the former sending is
completed.
Note:
L To cancel after programming, press {Stop} while the unit is idle, and then
press {Set}.
This feature is available when the sending / receiving fax machines are ECM
compatible.
{0} "OFF": Deactivates this feature.
{1} "ON" (default): If there is an error during fax transmission / reception, the
unit will support the communication.
If you often have trouble when sending faxes, this feature allows you to hear
connecting tones: fax tone, ring back tone and busy tone. You can use these
tones to confirm the status of the other party's machine.
{0} "OFF": Deactivates this feature.
{1} "ON" (default): You will hear connecting tones.
Note:
L If the ring back tone continues, the other party's machine may not be a fax
machine or may have run out of paper. Check with the other party.
L The connecting tone volume cannot be adjusted.
{1} "14.4Kbps"
{2} "33.6Kbps" (default)
Note:
L The fax speed maybe lower than the selected speed according to your line.
9. Programmable Features
67
Advertisement
Table of Contents
