Table of Contents
Advertisement
2.5.2 Using the automatic document feeder
1
1
Insert the document (up to 50 pages) FACE UP into
the feeder until a single beep is heard.
2
Adjust the width of the document guides (1) to fit
the actual size of the document.
Note:
L Confirm that there are no documents on the scanner
glass.
L Check that any ink, paste or correction fluid has dried
completely.
L Remove clips, staples or other fasteners.
L Do not insert the following types of documents:
(Make a copy of the document using the scanner
glass and set the copy instead.)
– Chemically treated paper such as carbon or
carbonless duplicating paper
– Electrostatically charged paper
– Badly curled, creased or torn paper
– Paper with a coated surface
– Paper with printing on the opposite side that can
be seen through the other side, such as
newsprint
L The total height of the documents when laid flat,
must be less than 5 mm. If the documents exceed
the capacity of the automatic document feeder, they
may fall or cause a jam in the feeder.
L To set a document with a width of less than 210 mm,
we recommend using the scanner glass to copy the
original document onto A4 or letter-size paper, then
setting the copied document.
L Do not set documents that do not satisfy the
requirements of size and weight. Make a copy of the
document using the scanner glass and set the copy.
L Available document size, document weight and
effective scanning area are as follows:
Minimum document size
128 mm
Maximum document size
216 mm
Effective scanning area
L Shaded area will be scanned.
4 mm
208 mm
216 mm
Document weight
L Single sheet:
2
45 g/m
to 90 g/m
L Multiple sheets:
2
60 g/m
to 80 g/m
Using the document tray extender
When you insert the legal-size paper, open the
document tray extender (1).
2. Preparation
4 mm
4 mm
4 mm
2
2
1
23
Advertisement
Table of Contents
