Table of Contents
Advertisement
2.2.7 (b) JAI, Inc. Power Cables
If you are using JAI, Inc. power cables such as the 12P-02S, please refer to the 12-pin connector pin-out
diagram in "12-Pin Connector (TM-1402)" on page 6. The cable pin-out diagram is shown in Figure 7 below. The
color-coded leads use Gray for Ground and Yellow for +12V.
Figure 7.
Jack
Pin#
1
2
3
4
5
6
Note: Make sure that the unused leads are not touching and that there is no possibility that exposed wires
could cause the leads to short.
2.2.7 (c) Building Your Own Power Cable
Refer to the 12-pin connector pin-out in Section 2.2.2 (a on page 6. Connect the Ground lead to pin #1, and the
+12V DC lead to pin #2 of the 12-pin connector. Power must be DC-regulated, and of sufficient current to
properly power the camera.
2.2.7 (d) Attaching the Power Cable to the Connector
The 12-pin connector is keyed and will only fit in one orientation. Follow these directions to properly attach
the power cable to the camera connector:
1.
Rotate the connector while applying slight pressure until the keyways line up.
2.
Press the connector into place until firmly seated.
3.
Plug the power cord into the AC socket. This will power the camera up.
2.2.8
Attaching the Analog Video Output
When connecting the TM-1402 to an analog frame grabber or a multisync monitor, use the BNC connector on
the rear panel of the camera. The input of the monitor should be balanced for 75Ω termination. Standard RG-
59 type coaxial cable should carry a full video signal for up to 100 feet.
The multi-conductor cable 12P-02S from JAI, Inc. can be used to transmit analog video, power, sync. signals,
and serial communication. The mini coaxial leads in JAI, Inc. multi-conductor cables are designed for short runs
of no longer than 100 feet.
Note: Make sure that no extraneous wires are visible which could cause a short.
2.2.9
Attaching the Camera Lens
The TM-1402 camera accepts 1/2" or larger format size C-mount lenses. To attach the C-mount lens to the
camera, carefully engage the threads and rotate the lens clockwise until it firmly seats on the mounting ring.
10
TM/TMC/RM/RMC-1402 Series
12P-02S Interface Cable (optional)
12P-02S Interface Cable
Lead Color
Function
Gray
Yellow
+12V DC
Red coax shield
Red coax
Orange coax shield
Orange coax
VINIT IN
Pin#
Lead Color
GND
7
8
White coax shield
GND
9
White coax
Video
10
GND
11
12
Black coax shield
Installation
+12 V
GND (Gray)
Power (Yellow)
Video Out (Red Coax)
}
HD In (White Coax)
VD In (Black Coax)
Function
Black coax
VD Input
Reserved
HD Input
Brown
RXD
Blue
Integration
TXD
Analog
Frame Grabber
Advertisement
Table of Contents
