San Router Firmware Default Values; San Router Firmware Default Values For Element Manager - IBM SAN04M-R Installation And Service Manual

SAN Router firmware default values

SAN Router firmware default values for Element Manager

Table 14
Element Manager parameters
System
R-Port Routing Cluster ID
Router Inband IP address
Router Subnet mask
Default Gateway address
SNMP Read-only Password
SNMP Read-modify Password
SNMP hosts
SNMP Traps
New Device Zoning
Element Manager Poll Interval (in secs)
10/100 BaseT management port
Management Port IP address (See note that
follows this table.)
Management Port Subnet Mask
Default Gateway
Multi-function Ports
If you need to restore the default values in the firmware, review
Table 14 as the table lists all default values and how you can change
or view the default values from Element Manager or SANvergence
Manager.
.
Default setting
1
192.168.110.100
255.255.255.0
0.0.0.0
public
private
None defined
None defined
Not a member of any
zone
30
0.0.0.0
0.0.0.0
0.0.0.0
Chapter 2: Installing and connecting the SAN Router
Element Manager menu hierarchy
Configuration>System>Operations
Configuration>System>Inband Address
Configuration>System>Inband Address
Configuration>System>Inband Address
Configuration>System>SNMP
Communities/Hosts
Configuration>System>SNMP
Communities/Hosts
Configuration>System>SNMP
Communities/Hosts
Configuration>System>SNMP Traps
Configuration>System>New Device Zoning
Options>Poll Interval
Configuration>Port>Management
Configuration>Port>Management
Configuration>Port>Management
31