Verify An Sp Switch Router Adapter Card On The Router; Verify Media Card Operation Using Ping - IBM 9077 Get Connected

To save an alternate configuration on the internal flash based upon the
currently running configuration on the internal flash device, use
grsnapshot -si -di=revision,version.
For more information about these commands, see GRF Reference Guide 1.4,
GA22-7367.

3.14 Verify an SP Switch Router Adapter Card on the Router

This section describes tools available with the SP Switch Router system
software to check out newly installed media cards. These tools are to be used
on the SP Switch Router:
• The
card can process and return a message.
• The
installed SP Switch Router Adapter card.
• The
Note: Output from logs and other system reporting functions refer to the SP
Switch Router Adapter card as DEV1, DEV_V1 or dev1.

3.14.1 Verify Media Card Operation Using ping

Check SP Switch Router Adapter media card viability using the
command. This UNIX command is modified to support SP Switch Router
board components. This use of
between the SP Switch Router control board and the specified media card. It
does not test message routing between media cards or communication
between media cards and external devices.
Note: The
operations.
The
ping -P grid <slot_number>
Switch Router Adapter card asking the card to respond back with another
message.
Follow these steps:
1. Log in as root to the SP Switch Router.
command tests whether an SP Switch Router Adapter media
ping
command tells you the operating state of an
grcard [port_number]
command allows you to reset the card.
grreset
command does not disturb normal SP Switch Router
ping
only tests internal communication
ping
command sends a message to a specified SP
Installation and Configuration
ping
97