Default Management And San Router Addresses; Default Tcp Port Addresses; Other San Router Defaults - IBM SAN04M-R Installation And Service Manual

Refer to Table 6 for the default setting for the Management Port IP
address, which is the only IP address that must be changed using CLI
to provide access for out-of-band management. All other default
setting can be changed using the Element Manager.
To set the SAN Router IP address, you can use one of three methods:
1. Connect a terminal to the RS-232 port on the SAN Router as
described in
Task 5: Connecting the VT100 or emulation terminal to
the RS-232 management port
2. Access the router using the Telnet protocol.
3. Access the router embedded Web-based management on the
10/100 management port using the default management IP
address.
Table 6

Default Management and SAN Router addresses

Port IP Address
Mgmt 192.168.100.100
SAN Router 192.168.110.100
inband

Default TCP port addresses

Table 7
Port Internal IP Address
3 192.168.111.103
(255.255.255.0)
4 192.168.111.104
(255.255.255.0)
Table 8

Other SAN Router defaults

Parameter
Zoning
mSAN ID
FC Port Type
Intelligent Port Interface
Chapter 2: Installing and connecting the SAN Router
on page 18.
Subnet Mask Default Gateway
255.255.255.0 0.0.0.0
255.255.255.0 0.0.0.0
Comment
User must set up the port IP address, subnet
mask and external router address.
User must set up the port IP address, subnet
mask and external router address.
Default Setting
No Zone (No devices zoned by default)
0
FC - Auto
Fast Ethernet (RJ45)
17