Task 5: Connecting The Vt100 Or Emulation Terminal To The; Rs-232 Management Port - IBM SAN04M-R Installation And Service Manual

Task 5: Connecting the VT100 or emulation terminal to the

RS-232 management port

18 SAN04M-R SAN Router Installation And Service Manual
Table 8 Other SAN Router defaults (Continued)
Parameter
Intelligent Port Type
E_Port Zone Policy
E_Port Connection Mode
Compression
MTU
Auto Reset on Severe Errors
Fast Write
Serial Port
To connect the terminal:
1. Use a null modem cable to connect a VT100 terminal or any
standard PC running terminal emulation software to the RS-232
serial port on the SAN Router.
• Connect female end of cable to the RS-232 port on the SAN
Router. See Figure 3, Management port to management terminal
connection.
• Connect the male end of the cable to the RS-232 port on the
terminal. See Figure 3, Management port to management terminal
connection.
Default Setting
iFCP
Append router zones
Open Fabric 1.0
Off
Auto
Enabled
Off
9600, 8, none,1, none