Table of Contents
Advertisement
Figure 12
Clean fiber-optic components
3. Gently wipe the end-face and other surfaces of the connector
with an alcohol pad as shown in part 2 of
pad makes full contact with the surface to be cleaned. Wait
approximately five seconds for cleaned surfaces to dry.
4. Repeat step 2 and step 3 of this procedure (second cleaning) and
again (third cleaning), then reconnect the fiber-optic cable to the
port.
1
Figure
Chapter 3: Maintenance and troubleshooting
2
12. Ensure the
47
Advertisement
Table of Contents
Troubleshooting
