Chapter 2: Installing and connecting the SAN Router
Installing the SAN Router
Table 5
Installation task summary
Task number and description
Task 1: Verifying installation
Task 2: Mounting the SAN
Task 3: Powering up the SAN
Task 4: Preparing to configure the SAN Router
Task 5: Connecting the VT100 or emulation terminal to the
RS-232 management
port.
© Copyright IBM Corp. 2007
Use the links below to access the major topics in this chapter.
Section
Installing the SAN Router
SAN Router firmware default values
You can mount the SAN Router on a horizontal surface such as a
table, or in a standard rack or cabinet. The following tasks listed in
Table 5, Installation task summary
procedures for correct installation.
requirements.
Router.
Router.
describe the sequence and
Required or optional
Required performed by IBM service personnel.
Required performed by IBM service personnel.
Required performed by IBM service personnel.
Required performed by customer.
Required performed by customer.
Page
11
24
25
26
27
28
29
31
Page
12
14
14
16
18
11