Appliance Preparation; Vent Collar Preparation - Heat & Glo TRUE-36C Installation Manual

6 6

Appliance Preparation

A. Vent Collar Preparation
CAUTION! Risk of Cuts, Abrasions or Flying Debris.
Wear protective gloves and safety glasses during instal-
lation. Sheet metal edges are sharp.
NOTICE: This appliance is top vented ONLY.
1. Remove shrink wrap from appliance. Figure 6.1 shows
the shipping location of the seal cap and heat shields
(Section 6), splatter guard and fi nishing templates
(Section 10), and the logs and Teco-Sil (Section 11).
2. Remove seal cap from top of appliance by removing
one screw, which is included, to prevent construction
material from getting into appliance. Remove seal cap
when pipe installation phase begins. See Figure 6.2.
3. Ensure gasket seal is in place prior to installing vent
pipe sections. Gasket is installed at the factory.
SPLATTER GUARD SPLATTER GUARD
HEAT SHIELDS HEAT SHIELDS
Figure 6.1 Shipping Location of Components
Heat & Glo • TRUE-36, TRUE-42, TRUE-50 Installation Manual • 2282-980 Rev. F • 8/14
LOGS LOGS
SEAL CAP SEAL CAP
SEAL CAP SEAL CAP
Figure 6.2 Seal Cap and Gasket Location
FINISHING FINISHING
TEMPLATES TEMPLATES
GASKET GASKET
TECO-SIL TECO-SIL
29