Install The Log Assembly - Heat & Glo TRUE-36C Installation Manual

G. Install the Log Assembly
Note: Refer to Section J for air shutter adjustment instructions.
Log Set Assembly: LOGS-TRUE36
Models: TRUE-36C, TRUE-36H, TRUE-36S
TRUE-42C, TRUE-42H, TRUE-42S
LOG PLACEMENT TABS LOG PLACEMENT TABS
Figure 1.
CAUTION: Logs are fragile, handle with care. Log #1 (2280-701 for TRUE-36, 2281-701 FOR TRUE-42): Locate log
placement notch on the bottom of log #1. See Figure 2. Mate outer notches on the bottom of Log #1 with the left and right grate
tines. Slide Log #1 toward the rear of appliance until back side of Log #1 contacts the log placement tabs. See Figures 1-3.
Figure 3.
Log #2 (2280-702 for TRUE-36, 2281-702 for TRUE-42): Locate log placement notch on the bottom of Log #2. See Figure
4. Mate notch on the bottom of Log #2 with the center and right grate tines. Slide log toward rear of appliance until right
end contacts the side grate tine. See Figure 5.
Log #2 (TRUE-36 ): Log #2 will be about 1 inch from the
back of the center grate tine when properly placed. See
Figure 5.
Log #2 (TRUE-42 ): Log #2 will contact center log placement
tab on center grate tine. See Figure 5.
Heat & Glo • TRUE-36, TRUE-42, TRUE-50 Installation Manual • 2282-980 Rev. F • 8/14
LOGS-TRUE42
TRUE-42 ONLY TRUE-42 ONLY
1 1
NOTCH FOR LOG #6 NOTCH FOR LOG #6
LOG PLACEMENT NOTCH LOG PLACEMENT NOTCH
Figure 2.
2 2
BURNED AREA BURNED AREA
LOG PLACEMENT NOTCH LOG PLACEMENT NOTCH
2 2
LOG PLACEMENT SLOTS LOG PLACEMENT SLOTS
Figure 4.
1 1
LEFT SIDE TOWARD REAR
Figure 5.
FLAT SPOT FOR LOG #3 FLAT SPOT FOR LOG #3
1 1
3 3
LOG CONTACTS LOG CONTACTS
SIDE GRATE TINE SIDE GRATE TINE
NOTCH FOR NOTCH FOR
LOG #3 LOG #3
2 2
51