Log Placement Instructions - Heat & Glo TRUE-36C Installation Manual

Note: Refer to Section J for air shutter adjustment instructions.
Log Set Assembly: LOGS-TRUE50
Models: TRUE-50C, TRUE-50H, TRUE-50S
LOG PLACEMENT TABS LOG PLACEMENT TABS
Figure 1.
CAUTION: Logs are fragile, handle with care. Log #1 (2282-701): Locate log placement notch on the bottom of log #1.
See Figure 2. Mate outer notches on the bottom of Log #1 with the left and right grate tines. Slide Log #1 toward the rear
of appliance until back side of Log #1 contacts the log placement tabs shown in Figure 1. See Figure 3.
1 1
Figure 3.
Log #2 (2282-702): Locate log placement notches on the bottom of Log #2. See Figure 4. Mate notches on the bottom of
Log #2 as shown in Figure 5. Notch on front of log will contact right front grate tine and notch on right side of log will contact
front inside corner of side grate tine.
NOTCH FOR NOTCH FOR
LOG #3 LOG #3
NOTCH FOR NOTCH FOR
LOG #4 LOG #4
LOG CONTACTS LOG CONTACTS
GRATE TINE GRATE TINE
Figure 5.
54 Heat & Glo • TRUE-36, TRUE-42, TRUE-50 Installation Manual • 2282-980 Rev. F • 8/14
FLAT AREA FLAT AREA
FOR LOG #3 FOR LOG #3
1 1
2 2

LOG PLACEMENT INSTRUCTIONS

NOTCH FOR LOG #6 NOTCH FOR LOG #6
LOG PLACEMENT NOTCH LOG PLACEMENT NOTCH
Figure 2.
NOTCH FOR NOTCH FOR 2 2
BURNED AREA BURNED AREA
LOG #4 LOG #4
LOG PLACEMENT SLOTS LOG PLACEMENT SLOTS
NOTCH NOTCH
Figure 4.
NOTCH FOR LOG #3 NOTCH FOR LOG #3
1 1
3 3
2 2