Vent Diagrams - Heat & Glo TRUE-36C Installation Manual

F. Vent Diagrams
WARNING! Risk of Fire. This appliance requires a minimum of 24 inches of vertical venting before attaching any elbow to
the appliance. DO NOT attach elbow directly to the appliance.
General Rules:
• This appliance is approved for use with Hearth & Home Technologies DVP venting systems ONLY.
• When penetrating a combustible wall, a wall shield fi restop must be installed.
• When penetrating a combustible ceiling, a ceiling fi restop must be installed.
• This appliance requires a minimum of 24 inches of vertical pipe attached directly to the appliance starting collar before
attaching a 90 degree or 45 degree elbow.
Top Vent - Horizontal Termination
One Elbow
Note: Flue restrictor is permit-
ted ONLY on 30 ft. minimum
vertical runs with no elbows.
TRUE-36 (NG/LP), TRUE-42 (NG),
TRUE-50 (NG/LP)
V Minimum H
1
2 ft 610 mm 7 in*
2.5 ft 762 mm 17 in
3 ft 914 mm 2 ft
4 ft 1.2 m 4 ft
5 ft 1.5 m 9 ft
6 ft 1.8 m 12 ft
7 ft 2.1 m 14 ft
10 ft 3.0 m 20 ft
20 ft 6.1 m 40 ft
After V = 6 ft then H = 2 x V ft Maximum
1 1
V + H = 60 ft Maximum
1 1
*when used with approved termination caps
TRUE-42 (LP)
V Minimum H
1
3 ft 914 mm 10 in.
4 ft 1.2 m 4 ft
5 ft 1.5 m 9 ft
6 ft 1.8 m 12 ft
7 ft 2.1 m 14 ft
10 ft 3.0 m 20 ft
20 ft 6.1 m 40 ft
After V = 6 ft then H = 2 x V ft Maximum
1 1
V + H = 60 ft Maximum
1 1
*when used with approved termination caps
Figure 4.6
Heat & Glo • TRUE-36, TRUE-42, TRUE-50 Installation Manual • 2282-980 Rev. F • 8/14
Maximum
1
178 mm
432 mm
610 mm
1.2 m
2.7 m
3.7 m
4.3 m
6.1 m
12.2 m
Maximum
1
254 mm
1.2 m
2.7 m
3.7 m
4.3 m
6.1 m
12.2 m
WARNING! Risk of Fire!
• TRUE-36(NG/LP), TRUE-42(NG), and TRUE-50(NG/LP) models
require a minimum of 24 inches of vertical venting before attaching
any elbow to the appliance.
• TRUE-42(LP) model requires a minimum of 36 inches of vertical
venting before attaching any elbow to the appliance.
DO NOT attach elbow directly to the appliance.
H
1
V
1
19