Heat & Glo TRUE-36C Installation Manual page 37

NOTICE: DO NOT wire
110-120 VAC to wall switch.
Romex
Connector
14/2WG
GRN wire
inside box
Copper ground
attached to GRN
screw with GRN wire
Figure 8.2 Junction Box Detail
Accessories Requirements
• This appliance may be used with a wall switch, wall
mounted thermostat and/or a remote control.
Wiring for optional Hearth & Home Technologies approved
accessories should be done now to avoid reconstruction.
Follow instructions that come with those accessories.
• Hearth & Home Technologies recommends that Intel-
liFire Plus wireless controls be used for their features
TM
and functionality with the IntelliFire Plus
tem.
Electrical Service and Repair
WARNING! Risk of Shock! Label all wires prior to dis-
connection when servicing controls. Wiring errors can
cause improper and dangerous operation. Verify proper
operation after servicing.
WARNING! Risk of Shock! Replace damaged wire with
type 105º C rated wire. Wire must have high temperature
insulation.
Heat & Glo • TRUE-36, TRUE-42, TRUE-50 Installation Manual • 2282-980 Rev. F • 8/14
ignition sys-
TM
37