Attaching To The Stand - Nikon SMZ1500 Instructions Manual

lamp, handle it through a piece of cloth or through its packaging
until replacement is complete. If you get fingerprints on the lamp,
wipe gently with a piece of clean cloth dampened with alcohol.

Attaching to the stand

2
It is possible to freely adjust the direction of
illumination by using the Epi arm.
Slightly loosen the clamp knob on the Epi
arm. Screw in the mounting screw at the end
of the Epi arm into the screw hole for
mounting accessories on the stand base while
turning the joint. Next, securely tighten the
nut using the supplied wrench. Then, screw
the mounting screw at the other end of the Epi
arm into the screw hole on the illuminator in
the same manner as described above. The
illustration shows the example of C-DSLS.
Illuminator
Clamp knob
Simultaneousl
y clamps two
arms/joints.
Arm
Joint
Spanner
Nut
Mounting
screw
V
25