Installation of the Episcopic Stand
Install the episcopic stand on a level and stable surface.
Refer to page 3, "Notes on Handling the System" for installation
location.
Removing cushioning materials
The substage section is secured with cushioning materials.
Turn the stage height adjustment knob to raise the substage
and remove the cushioning materials.
The AZ-STD Diascopic Stand is required to use the
diascopic illumination. For the installation of the diascopic
stand, see the instruction manual for the AZ-STD Diascopic
Stand and the AZ-STGD DIA Stage.
Clamp screw holes
The Episcopic stand has two clamp screw holes on the back.
They can be used for fixing the stand to a base or a pedestal.
For the dimensions of the screw holes, refer to the right figure.
Installation of the EPI Stage
Attach the EPI stage to the substage of the episcopic stand.
1.
Remove the fastening hardware from the stage
board.
The fastening hardware is secured with four hexagonal
socket head screws. Remove the screws with the 3 mm
hexagonal wrench provided with the stage.
2.
Place the EPI stage on the substage and secure it
by fixing the provided four M4 screws.
Secure the screws with the 3 mm hexagonal wrench
provided with the stage.
For the installation of the AZ-STGD DIA Stage, see the
instruction manual for the AZ-STD Diascopic Stand and the
AZ-STGD DIA Stage.
Chapter 4 Aseembly
18
Substage
Remove the
cushioning materials.
Removing cushioning materials
200
Clamp screw hole dimensions
EPI stage
EPI stage installation
2-M6 depth12