Oki 182 Handbook page 26

ML182/183 __________________________________
-
NOTE:
If
you have the optional interface board installed, this switch bank is located
on the lower board.
-
Switch 1 selects either
¢/¢
or
¢/¥
character set in the location of
I BM character set (9 B) Hand (9 D) H respectively, depending on
the setting. Set to OFF, the printer will power up in the
' P IC/>
character set. And set to ON, the printer will power up in the
¢/¥
character set.
-
It is recommended that you set the printer to print the character
set you will be using most often.
-
Switch 2 is set in the OFF position and establishes 10 CPI as the
default character pitch; in the ON position, 17.1 CPI is established
as the default character pitch.
­
Switch 3 controls the automatic line feed. It is set in the OFF posi ­
tion because the IBM Personal Computer automatically sends a car­
riage return to the printer at the end of each line. Set in the ON
position, switch 3 provides automatic double spacing.
­
Switches 4 and 5 work together to select the length of the paper in
­
the printer. The setting before shipment is as follows:
11 inches for 240-V version
-
12 inches for 220-V version
The paper length selections are:
11-213 inches
8.5 inches
11 inches
12 inches
4
OFF
OFF
ON
ON
-
-
OFF
ON
OFF
ON
-
Switch 6 is the automatic "skip over perforation" setting, which is
factory set in the OFF position. When it is set in the ON position, the
printer automatically advances paper from the last line of one page to
the first line of the next page, skipping over the perforation between
pages.
18