Oki 182 Handbook page 114

-
ML182/183 __________________________________
­
-
Type C again, then enter the name of your printer. This will be
the name WordStar uses inany messages concerning the
printer you've installed. You can use up to 34 characters to
name your printer. You could, for example, name your printer
"OKI MICROLlNE", or you could name your printer
something more personal, such as "Splendid," Then press
<CR> and the screen will show your entry and ask you to
verify it. If it's correct, simply press <CR>; if you wish to
change it, press
l:i.:.
Selections
II
I,"
1/
0,"
1/
P," and
II
Q" in the Printer.1 nstallation
Menu will be used in our examples to install your OKI _
MICROLINE printer features into patch locations which
correspond to the assigned functions found in the Control
P Menu of WordStar.
After the insertion of each patch, WINSTALL will request
verification of the code sequence. If it was entered cor­
rectly, all you need to do is press <CR> and continue.
However, if an error was made, you must press the N key
to reenter the data.
WINSTALL allows the patch codes to be entered in three
different formats-ASCII, hexadecimal, and decimal. To en­
ter a code in ASCII, type a colon followed by one character
of the code. Hexadecimal codes may be preceded by a
comma or entered directly. Thus, ESC may be typed as
,1
B
or simply
1
B. Decimal codes must be preceded by the
pound sign (#). ESC would be typed as #27. Hexadecimal
-
is easiest, so we'll use that format.
-
Each patch code must be entered one character at a time
and you must press <CR> after each character. To termi­
nate an entry, you must enter a period after the last code­
provided that the maximum number of entries has not been
exceeded.
-
98