Oki 182 Handbook page 136

ML182/183 _ _ _ _ _ _ _ _ _ _ _ _ _ _ _ __
Pi
18
+5 V
From
printer
+ 5 V supply
(50 mA max.)
19
to
30
OV Twisted-pair return
(for pin No.1 to
No. 12).
31 I-Prime To printer Clear/resetli n itial ize.
Low pulse.
32 Fault
From
printer
The level of this
signal is low when
the pri nter:
1. Is in the paper
end state
2. Is in the error
state
33
OV No
return
Logic ground
34 Not used
to
36
Serial Cable
The Microline 182/183 requires an RS232-C shielded cable, UL
and CSA (equivalent to European standards) approved, no more
than 50 feed in length, with the following:
Cannon DB-25P plug (or equivalent) with 25 pins
Cannon DB-2C-J9 (or equivalent) connector shell
High-Speed Serial Interface Signal Requirements:
NOTE TO USER: This board only supports printer Ready/Busy protocol.
If
your
computer uses X-ON/X-OFF protocol, you must install the super-speed serial board.
-
-
-
-
-
-
-
-
-
-
-
-
-
-
118