Precautions; Installation - Toshiba e-STUDIO25 Operator's Manual

4. PRECAUTIONS

1. Installation

1 The e-STUDIO16/20/25 should be installed by an authorized TOSHIBA service technician.
1
Note
The packing material should be disposed of properly.
2
2
To obtain the best possible results, this machine should be used in conjunction with a
dedicated AC power line at the following ratings:
110-127 VAC, 50/60 Hz, 1.4 kW or less
3
Note
1. The use of other appliances or other equipment on the same line as this machine may adversely
affect performance and copy quality.
2. Be sure to use a 3-conductor, grounded wall outlet.
4
3. In areas where a 2-pin plug is used, the copier must be grounded for safety.
Never ground it to a gas pipe, a water pipe, or any other object not suitable for grounding.
3 After a suitable place has been selected for installation of the e-STUDIO16/20/25, please
5
avoid frequent movement. Avoid excessive heat, dust, vibration and direct sunlight.
Also, provide proper ventilation as the copier emits a small amount of ozone.
Note
6
1. The recommended environmental range for use is as follows:
• Temperature:
• Humidity:
7
2. To ensure optimal operation, allow clearances of at least 32" on the left, 32" on the right and 4" in
the rear (refer to the illustration below).
8
9
10
11
The e-STUDIO should be placed near an outlet that is easily accessible.
12
8
PRECAUTIONS
10~30°C/50~86°F
20~85% RH
4 inches
32 inches
32 inches