Toshiba e-STUDIO25 Operator's Manual page 131

4. REPLACING PROCESS UNIT (Cont.)
8 Grasping the colored handle on top of the Process
1
Unit, remove the Process Unit from the copier.
2
3
9 Discard the used Process Unit properly.
4
10 Open the package and take the new Process Unit
out.
11 Pull the tab to remove the sealing tape from the
5
Process Unit.
Important
• Never touch the photoconductive drum (the green surface)
6
of the Process Unit. If the surface is scarred or scratches, it
will cause print quality problems.
• Do not expose the photoconductive drum of the process
Unit to light for more than 3 minutes. If the Process Unit is to
be left anywhere outside the copier, be certain to cover it
7
with cloth, paper, etc.
12 Insert the new Process Unit all the way into the
copier. Then install the Toner Cartridge by reversing
8
the removal procedure.
• Always hold the Process Unit by the colored handle. Do not
touch the green drum area. Do not leave the Process Unit
out of the copier for an extended period of time.
9
10
13 After installing the Toner Cartridge, move the
charger wire cleaning lever (in and out) of the
Process Unit several times to clean the charger
wire.
11
12
14 Close the covers opened during this procedure and
latch the deplexing unit into position (if attached).
7-10
WHEN THE GRAPHIC SYMBOL FLASHES