The Www Screen; The Telnet Screen - ZyXEL Communications EMG2306-R10A User Manual

• Your EMG2306-R10A can act as an SNMP agent, which allows a manager station to manage and
monitor the EMG2306-R10A through the network. Use the SNMP screen to configure SNMP
settings. You can also specify from which IP addresses the access can come
page 124).
• Use the TR069 screen to configure the EMG2306-R10A's TR-069 auto-configuration settings
(Section 18.7 on page
• Use the Import CA screen to import CA certificates to the EMG2306-R10A
128).

18.4 The WWW Screen

To change your EMG2306-R10A's remote management settings, click Configuration >
Management > Remote MGMT to open the WWW screen.
Figure 67 Configuration > Management > Remote MGMT > WWW
The following table describes the labels in this screen.
Table 52 Configuration > Management > Remote MGMT > WWW
LABEL
Port
Access Status
Secured Client IP
Address
HTTP
Apply
Cancel

18.5 The Telnet Screen

You can use Telnet to access the EMG2306-R10A's command line interface. Specify which interfaces
allow Telnet access and from which IP address the access can come.
EMG2306-R10A User's Guide
127).
DESCRIPTION
You may change the server port number for a HTTPS service if needed. However you
must use the same port number in order to use that service for remote management.
Select the interface(s) through which a computer may access the EMG2306-R10A using
this HTTPS service.
Select All to allow all computers to access the EMG2306-R10A.
Otherwise, check Selected and specify the IP address of the computer that can access
the EMG2306-R10A.
Click Apply to save your customized settings and exit this screen.
Click Cancel to exit this screen without saving.
Chapter 18 Remote Management
(Section 18.6 on
(Section 18.8 on page
123