Drive-Wheels - Agria 400E Operating Instructions Manual

3. Devices and Operating Elements
3
J
1
1 Detent spring
26 agria Multi-Purpose Machine 400E/400K

Drive-Wheels

Only mount and dismount
W
drive-wheels
turned off.
The drive-wheels are equipped with a
detent spring (1) and can be mounted
and adjusted without tools.
The detent spring engages into a ring
groove on the wheel-shaft to hold the
drive-wheel.
On both sides of the wheel-shaft there
are 2 ring grooves respectively. With
detent spring engaging into outer ring
groove, the drive-wheel turns in neutral
on wheel-shaft. With detent spring en-
gaging into inner ring groove, the drive-
wheel engages with a toothed wheel on
the wheel-shaft to be driven by the
same.
Mounting drive-wheels
For full tractive power, mount
I
field tyres with the tread profile
pointing in travel direction (seen from
above).
Lift detent spring (1) slightly and place
into assembly position (fig. J) (front ring
groove on hub).
Mount drive-wheels onto wheel-shaft,
with the side for the detent spring point-
ing outwards.
Let detent spring engage in a ring
groove again (fig. K and L).
Brush Bio-lubricating grease onto
both ends of wheel-shaft (small diam-
eter of wheel-shaft).
For dismounting drive-wheels, proceed
accordingly but in reverse order.
with engine