Working; Danger Zone - Agria 400E Operating Instructions Manual

4. Commissioning and Operation
Operation
Check safety circuit function
W
- only operate the machine if the
safety circuit is working.
Couple the attachment.
Set the correct ground speed for the
attachment.
Set drive-wheels to position "drive".
Switch on wheel drive with hand lever
(E/11 or G/11).
For pto-driven attachments: move pto
lever (A/1 or H/6) to "I".
Slightly pull on hand clutch lever (E/4
or G/4), unlock pawl (E/5 or G/5), release
slowly and press the throttle. The pto-
driven attachment starts moving and the
multi-purpose machine travels forward.
Reverse
Move speed
5
NEUTRAL/IDLE POSITION.
Pull hand clutch lever (E/4 or G/4) to
middle position and wait until the machine
stops moving forward.
Pull hand clutch lever all the way up
and press the trottle at the same time.
If cleaning becomes neces-
W
sary during operation, cut out
the engine and remove spark plug con-
nector for safety reasons.
44
Wear individual protec-
tive ear plugs and solid
shoes.
control lever
agria Multi-Purpose Machine 400E/400K
End of operation:
Switch off wheel-drive. To do this,
pull hand lever for wheel drive (E/11
or G/11) and lock pawl.
Pull hand-clutch lever (E/4 or G/4)
and lock pawl.
For pto-driven attachments: Move
the pto-lever (A/1 or H/6) to position
"0".
Turn off the engine.
Immediately re-install any
W
guards on the attachment
(e.g. knife strip on the cutterbar).

Danger zone

Keep out of the machine's
W
danger zone during starts
and operation.
Mowing: danger zone
to
Hoeing: danger zone