Drive-Wheels - Agria 3100 Operating Instructions Manual

3. Devices and Operating Elements

Drive-Wheels

The single-wheel power hoe has a cen-
trally fitted rubber drive-wheel as stand-
ard equipment.
Mounting Drive-Wheel
Insert single-wheel shaft (1) into shaft
bearing. Push in from left to right (in travel
direction).
Fit drive-wheel (2) onto shaft end and
fasten with hexagonal screw (3) and
counternut (4). For this purpose, push
screw through borings in hub and wheel
shaft.
I
Mount drive-wheel with pointed
parts of lugs showing in travel
direction (forward).
Two-Wheel Axle
(Item no. 3190 011)
Track width ............................. 300 mm
Total width .............................. 380 mm
Mounting Two-Wheel Axle
Remove hexagonal screw (B/12) from
drive-wheel/wheel shaft and remove
drive-wheel.
Remove single-wheel shaft. Pull out
to the left.
Insert two-wheel shaft (3) into shaft
bearing. Push in from left to right [the
Edition 03.95
long end is on the right side (in travel
direction)].
wheel shaft end.
right end of the wheel shaft and fasten
with linch pin. Push linch pin through hub
and wheel shaft borings.
end and also fasten with linch pin (5).
I
Single-wheel power hoe 3100
Slide distance pipe (2) over the right
Fit removed drive-wheel (1) onto the
Fit drive-wheel (4) onto the left shaft
Mount drive-wheel with pointed
parts of lugs showing in travel
direction (forward).
21