Drive-Wheels; Snow Chains; Twin-Wheels - Agria 5500 KL Operating Instructions Manual

3. Devices and Operating Elements

Drive-Wheels

For full tractive power, mount wheels
with pointed parts of lugs showing in
travel direction (wheels seen from
above). Fit the countersunk side of
spring-lock washer into countersink-type
holes of disk wheel (see fig. "Wheel Fas-
tening Screws", p.21).

Snow Chains

When working with snow chains fitted
on wheels, observe manufacturer's in-
structions, make sure there is sufficient
clearance between chains and machine
parts.

Twin-Wheels

For mowing on extremely steep
slopes, we recommend using twin-
wheels, wheel centres or strake wheels.
Differential Hubs with
Anti-Wind-on Pipes
Item No. 5616 511 (without wheels)
20 Municipal Tool Carrier 5500 KL Edition
Differential hubs are mounted onto hub
adapter of machine, version B, with
wheel fastening screws (refer to p21).
Fit countersunk spring lock washers
between drive-wheel and hub adapter.
The differential effect of hubs for twin
tyres is factory-set.
However, you can also fit twin wheels
rigidly. For this purpose, proceed as fol-
lows.
Remove snap ring (7) and thrust
washer (6).
Slightly pull out the outer wheel to-
gether with wheel flange and twist until
driving of wheel flanges between both
driving pins of the wheel flange shaft
comes to a stop.
Push wheel fully onto wheel flange
shaft and fit snap ring.
Use a grease gun to lubricate wheel
flange nipple (with Bio-grease) after
every 50 operating hours.
03.95