Installation Without A Flue Connected - Cannon Fitzroy Inbuilt Installation Instructions Manual

User, service instructions

Hide thumbs

Table Of Contents

Table of Contents

Enlarged version

3. Switch the control buttons to 'High flame' position as indicated in figure 27

and using a spanner adjust the pressure to 0.75 kPa for Natural gas or

2.65 kPa for LPG. (Turn clockwise to increase pressure and anticlockwise

to decrease pressure).

4. Switch the control buttons to 'Low flame' position as indicated in figure 28.

Retain spanner in position and using a screwdriver adjust the central screw

control to give a pressure reading of 0.4 kPa for Natural Gas and 1.1 kPa

for LPG. (Turn clockwise to increase pressure and anticlockwise to

decrease pressure).

5. Switch heater off and remove the manometer tube. Tighten pressure test

point by turning the captive screw fully clockwise.

6. Replace plastic cap. Ensure the little lug is positioned towards lower right

hand side to clear the controls.

7. Refit the fascia, making sure not to damage the power cord or switch cable.

8. Follow user instructions to turn on heater.

Operate the heater of HIGH, MEDIUM and LOW settings.

The flame should be stable, no lifting from the burner and the logs should

glow after approximately 15 minutes of operation at HIGH burner.

If the flame is unstable:

Check that the burner is located correctly.

Check that the glass front is located correctly and is against the sealing

rope.

Check that the gas pressure is correctly adjusted.

If the heater still does not operate to specification refer to the troubleshooting

chart on pages 20 & 21, or contact Sampford IXL in your state.