Log Installation; Front Fascia Removal - Cannon Fitzroy Powerflue In-built Operation Instructions Manual

FRONT FASCIA REMOVAL

1. Remove the wire mesh grille by gently lifting it upwards and then outwards.
Similarly remove a fitted glass kit by also gently lifting it upwards and then
outwards.
2. Remove 4 M5 screws fixing the fascia assembly to the heater body. Bring the
bottom of the fascia towards you gently to partly disengage it from the body of
the heater. After it has been disengaged gently lift it up vertically to completely
disengage it from the body of the heater. Refer figure 12.
FIG 12.
To fully remove the fascia, unclip the switch cable
from the cable connector on the PCB and unclip the
cable from the clipping points on the rear of the
fascia.
3. To remove the inner glass: see Fig14.
Loosen off all the clamp screws.
Completely remove the one vertical side
and the top clamp.. Try not to touch the
front surface of the glass to avoid finger
marks. Remove the glass by sliding the
glass sideways out of the clamp and then
lifting out from the bottom. Place the glass
in a safe position for refit later.
14
17
FIG 13.
FIG 14.

LOG INSTALLATION

FIG 15.
SHOWS POSITONING OF LOGS RELATIVE TO EACH OTHER.
REFITTING FRONT GLASS
Refit the front glass, slide into lower clamp and then
under side clamp. Make sure that it is seated evenly on
sealing rope. replace top and side clamp and secure.
Make sure not to over tighten the clamp screws.
Note: An air tight seal is to be achieved between
glass and seal. Care should be taken to achieve this.
FIG 16.
Carefully unpack the log set. Logs are numbered
as follows:
no1 left front
no2 left back
no3 right front
no4 right back log.
Position the four individually numbered logs in the
following order on the burner as shown in fig.15
The male locating pins in the burner must engage
with the corresponding holes in the individual logs.
see fig 15.
(a) Place log no 1 onto the 2 front pins
on the burner head, ensuring that the
charring faces the front.
(b) Place log no 2 onto the two left
back pins.
( c) Place log no 3 onto the single
right front pin, ensure the fork locates
over log no 2.
(d) Place log no 4 onto the single right
back pin, ensurezeft side of log rests in
the depression in log no 3.
15