Wiring Diagram - Hitachi C 10FSB Technical Data And Service Manual

11-4. Wiring Diagram

The Models C 10FSH and C 10FSB are equipped with an overload protection circuit.
Carefully ensure that wiring is accomplished as illustrated below. As incorrect wiring will result in lack of rotation,
reverse rotation or other malfunctions, close attention is absolutely necessary.
[WARNING] Be sure to turn off the Switch (W/Cover) [156] on the side of the handle and unplug the power
cord plug from the receptacle before replacing the Laser Marker [99] and the Switching Power
Supply [144]. Do not disconnect Connector (B) [145] that connects the Laser Marker [99] with
the Switching Power Supply [144] while the Laser Marker [99] is lighting. Otherwise, the Laser
Marker [99] may be damaged due to surge (electricity stored in the Switching Power Supply
[144]). Do not stare into beam while the Laser Marker [99] is lighting.
1 Wiring diagram
C 10FSH USA/CAN
Armature
ass'y
Brake coil
Stator coil
Stator ass'y
These numbers indicate the terminal
numbers of the trigger switch.
Red
Blue
Yellow
Gray
Controller ass'y
Power
module
Red
Black
Red
White
AC 120 V
Fig. 69-1
--- 49 ---
SW
Black
OFF
White
White
Black
Black
SW
Black
Black
White
White dotted line
on the black
DC 6 0.5 V
Input
AC 120 V
Laser module