Hitachi C 10FSB Technical Data And Service Manual page 35

Cutting method of crown molding without tilting the saw blade
Crown molding vise ass'y
(optional accessories)
6 mm knob
bolt
6 mm
knob
bolt
Crown molding stopper (L)
(optional accessories)
6 mm wing bolt
Fig. 49-1
Crown molding vise ass'y
(optional accessory)
6 mm knog bolt
V-groove
Groove
Fence
6 mm wing bolt Crown molding
Fig. 49-2
To ensure that the tip of the 6-mm wing bolt is properly aligned with the desired locking groove on the vise
shaft, simply align the upper surface of the fence to either of three v-grooves on the vise shaft surface or to the
lower surface of the screw holder. Therefore, the vise assembly can be attached in either of three positions to
ensure proper height adjustment. After adjusting the height, firmly tighten the 6-mm wing bolt; then turn the
upper knob, as necessary, to securely attach the crown molding in position. (See Fig. 49-2.)
WARNING: Always firmly clamp or vise to secure the crown molding to the fence; otherwise the crown
molding might be thrust from the table and cause bodily harm. Do not perform bevel cutting.
The main body or saw blade may contact the sub fence, resulting in an injury.
CAUTION: Always confirm that the motor head does not contact the crown molding vise ass'y when it is
lowered for cutting. If there is any danger that it may do so, loosen the 6-mm knob bolt and
move the crown molding vise ass'y to a position where it will not contact the saw blade.
Crown molding stopper (R)
(Optional accessories)
Knob
Crown molding stopper (L)
Crown molding stopper (R)
(optional accessories)
(1) Crown molding stopper (L) and (R) (optional
accessories) allow easier cuts of crown molding without
tilting the saw blade. Install them to both sides of the
base as shown in Fig. 49-1. After inserting, tighten the
6-mm knob bolts to secure the crown molding guides.
[ Optional accessories used ]
Crown molding vise ass'y
(include crown molding stopper (L))
Crown molding stopper (L)
Crown molding stopper (R)
(2) The crown molding vise ass'y (optional accessory) can
be mounted on either the left fence (fence (B)) or the
right fence (fence (A)). It can unite with the slope of the
crown molding and vise can be pressed down. Then
turn the upper knob, as necessary, to securely attach
the crown molding in position. To raise or lower the vise
assembly, first loosen the 6-mm knob bolt. As shown in
Fig. 49-2, the vise shaft has three locking grooves into
which the tip of the 6-mm wing bolt is designed to fit in
order to lock the screw holder in the desired position.
--- 31 ---