Reverse the door as follows:
Disconnect the power to the machine.
Remove the top cover.
Remove the operating panel with the PCB by
removing the 2 multi-plugs, G1 and G2.
Remove the lock system, A.
Remove the 2 leads on the door switch.
Remove screws B with gaskets and screws C
and E (fig. 9).
Remove screws D, taking care because the
door is now hanging loosely on the front
panel (fig. 9).
Switch cover plate and dust hood.
Move the leads to the opposite side. Be
careful with the leads, so that they will not get
caught by the drum or when mounting the
Mount the front panel with door in such a way
that the hinges are on the opposite side.
Mount the lock system, A (must be reversed).
Mount the operating panel and the PCB.
Insert multi-plugs G1 and G2.
Mount the top cover.
Connect the machine to the power source
and test the machine.
Installation GAS 200/270 litres