Advertisement
Advertisement
Related Manuals for Electrolux TS-5121
Summary of Contents for Electrolux TS-5121
- Page 1 Installation and Operating Manual Model:- TS-5121 Orig. 10/13...
-
Page 2: Table Of Contents
CONTENTS ABOUT THE OPERATING MANUAL Page 2 IMPORTANT SAFETY INSTRUCTIONS Page 3 INSTALLATION INSTRUCTIONS Page 4 OPERATING INSTRUCTIONS Page 8 MAINTENANCE INSTRUCTION Page 9 TECHNICAL DATA Page 9 DIMENSIONS Page 10 ABOUT THE OPERATING MANUAL This manual describes the cabinets functions and operation and includes instructions for installation and maintenance. -
Page 3: Important Safety Instructions
IMPORTANT SAFETY INSTRUCTIONS IMPORTANT These instructions and warnings have been provided to help avoid misuse and unnecessary risks and should be read before the cabinet is installed and used. NOTE: Keep this manual in a safe place so that it is always available for future use. WARNING ... -
Page 4: Installation Instructions
INSTALLATION INSTRUCTIONS UNPACKING INSTALLATION Check for external signs of damage to the The dryer is only designed for operation packaging. This may indicate that the con- indoors in a dry environment at a temperature signment has suffered damage in transit. Any above freezing point. - Page 5 INSTALLATION INSTRUCTIONS (cont.) INSTALLATION WHERE ACCESS SPACE IS LIMITED The upper section of the cabinet can be removed to reduce the overall height by 207mm. Remove two T20 screws from the under edge of the fascia panel located through the square holes, then slide the panel upwards. Loosen the four T20 screws securing the door switch bracket and slide it backwards.
- Page 6 INSTALLATION INSTRUCTIONS (cont.) EXHAUST CONNECTION The exhaust ducting should not be connected into an existing chimney, boiler flue or tumble dryer system. The dryer must be connected directly to an exhaust ducting system that terminates on the outside of the building. This could be through the roof or on an external wall.
- Page 7 INSTALLATION INSTRUCTIONS (cont.) ELECTRICAL CONNECTIONS U.K. All electrical work should be carried out only by a suitably qualified and competent person, in strict accordance with national and local safety regulations. Ensure that power is not connected to the All supply cables into the cabinet should be appliance while installation work is being clamped using the glands fitted to the top carried out.
-
Page 8: Operating Instructions
Model TS-5121 An automatic cool down period of approximately 8 minutes is built into each The cabinet is fitted with a stainless steel cycle. -
Page 9: Maintenance Instruction
MAINTENANCE INSTRUCTIONS CLEANING High pressure water jet cleaning should not used on this cabinet. The use of bleach, caustic solutions and abrasive materials is not recommended. The cabinet should be cleaned (inside and out) with a damp cloth using a mild detergent solution. -
Page 10: Dimensions
DIMENSIONS Notes: Minimum clearance required for access with the cabinet removed from pallet: Width: 610mm Height: 1850mm Maximum levelling adjustment: Plus 25mm Minimum clearance required in front of the cabinet with the hanging rail fully extended: 820mm Doors open to 180 degees and extend 430mm from the end panels. - Page 11 BLANK PAGE Installation and Operating Manual Page 11...