Ending A Call; Using Hold And Resume - Cisco 7961G Phone Manual

Ending a Call

To end a call, hang up. See the following table for details.
If you want to...
Hang up while using the handset
Hang up while using the headset
Hang up while using the speakerphone Press
Hang up one call but preserve another
call on the same line

Using Hold and Resume

You can hold and resume calls. When you put a call on hold, the Hold icon
caller ID and the corresponding line button flashes green
If the Hold Reversion feature is enabled for your phone, calls that you leave on hold will revert back
to ringing on your phone after a certain length of time. These "reverting" calls remain on hold until
you resume them.
Your phone indicates the presence of a reverting call by:
• Alerting you at intervals with a single ring (or flash or beep, depending on your phone line setting).
• Briefly displaying a "Hold Reversion" message in the status bar at the bottom of the phone screen.
• Displaying the animated Hold Reversion icon
• Displaying a flashing amber line button
If you want to...
Put a call on hold
28
Then...
Return the handset to its cradle. Or press EndCall.
Press
EndCall.
Press EndCall. If necessary, remove the call from hold first.
Then...
1. Make sure the appropriate call is highlighted.
2. Press Hold.
. If you want to keep headset mode activate, press
or EndCall.
.
next to the caller ID for the held call.
(depending on the line state).
appears next to the
OL-10777-01