Removing The Coin-Cell Battery - Dell Inspiron One 2305 Service Manual

Coin-Cell Battery: Dell Inspiron One 2305/2310 Service Manual
Back to Contents Page
Coin-Cell Battery
Dell™ Inspiron™ One 2305/2310 Service Manual

Removing the Coin-Cell Battery

Replacing the Coin-Cell Battery
WARNING: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
WARNING: A new battery can explode if it is incorrectly installed. Replace the battery only with the same
or equivalent type recommended by the manufacturer. Discard used batteries according to the
manufacturer's instructions.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to
servicing that is not authorized by Dell™ is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on your computer).
Removing the Coin-Cell Battery
1. Record all the screens in system setup utility (see
step 7.
2. Follow the instructions in
3. Remove the back cover (see
4. Follow the instructions from
5. Remove the system-board shield (see
6. Locate the battery socket (see
CAUTION: If you pry the battery out of its socket with a blunt object, be careful not to touch the system
board with the object. Ensure that the object is inserted between the battery and the socket before you
attempt to pry out the battery. Otherwise, you may damage the system board by prying off the socket or
by breaking circuit traces on the system board.
7. Press the battery release lever to remove the battery.
1 battery release lever
file:///T|/htdocs/systems/InsOne2310/sr/sm/coin_bat.htm[7/25/2012 10:24:55 AM]
System Setup
Before You Begin.
Removing the Back Cover).
step 2 to step 5 in Removing the Front
Removing the System-Board
System Board Components).
Utility) so that you can restore the correct settings in
Stand.
Shield).