Dell Inspiron One 2305 Service Manual page 36

System-Board Shield: Dell Inspiron One 2305/2310 Service Manual
10. Follow the instructions from
Replacing the System-Board Shield
1. Follow the instructions in
2. Follow the instructions from
3. Follow the instructions from
4. Route the antenna-in connector cable and infrared (IR) blaster connector cable through the routing guides on the
system-board shield.
5. Connect the IR blaster connector cable to the connector (CIR Emitter) on the system board.
6. Connect the antenna-in connector cable to the connector on the TV tuner card.
7. Carefully turn the system-board shield over and align the screw holes on the system-board shield with the screw holes
on the chassis.
8. Replace the four screws that secure the system-board shield to the chassis.
9. Follow the instructions from
10. Replace the back cover (see
CAUTION: Before turning on the computer, replace all screws and ensure that no stray screws remain
inside the computer. Failure to do so may result in damage to the computer.
11. Connect your computer and all attached devices to electrical outlets, and turn them on.
Back to Contents Page
file:///T|/htdocs/systems/InsOne2310/sr/sm/sb_shiel.htm[7/25/2012 10:24:50 AM]
step 5 to step 7 in Removing the Infrared (IR) Blaster
Before You Begin.
step 2 to step 5 in Replacing the Infrared (IR) Blaster
step 2 to step 3 in Replacing the Antenna-In
step 4 to step 5 in Replacing the Front
Replacing the Back Cover).
Connector.
Connector.
Connector.
Stand.