Dell Inspiron One 2305 Service Manual page 89

System Setup Utility: Dell Inspiron One 2305/2310 Service Manual
Displays the L1 cache size
L1 Cache Size
Displays the L2 cache size
L2 Cache Size
Displays the L3 cache size
L3 Cache Size
Memory
Information
Indicates the amount of memory installed in MB
Memory
Installed
Indicates the amount of memory available in MB
Memory
Available
Indicates the memory speed in MHz
Memory Speed
Indicates the type of installed memory
Memory
Technology
Device
Information
Displays the SATA drive connected to the SATA 0 connector
SATA 0
Displays the SATA drive connected to the SATA 1 connector
SATA 1
Advanced
CPU
Configuration
System
Configuration
Power
Management
Post Behavior
Security
Allows to set, change, or delete the administrator password
Admin
Password
NOTE:
password must be set before setting the system password.
Allows to set, change, or delete the system password
System
Password
Enabled or Disabled (Enabled by default)
Password on
Boot
Boot
Specifies the boot sequence from the available devices
1st Boot
Priority
USB Storage Device; Hard Drive; CD/DVD/CD-RW Drive; Diskette Drive; Network; Disabled (Hard Drive
file:///T|/htdocs/systems/InsOne2310/sr/sm/sys_setu.htm[7/25/2012 10:25:09 AM]
Hyper-Threading — Enabled or Disabled (Enabled by default)
Multi Core Support — All; 1; 2 (All by default)
Limit CPUID Value — Enabled or Disabled (Disabled by default)
CPU XD Support — Enabled or Disabled (Enabled by default)
Intel Virtualization Technology — Enabled or Disabled (Enabled by default)
Intel(R) SpeedStep — Enabled or Disabled (Enabled by default)
Onboard Audio Controller — Enabled or Disabled (Enabled by default)
Onboard LAN Controller — Enabled or Disabled (Enabled by default)
Onboard LAN Boot ROM — Enabled or Disabled (Disabled by default)
SATA Mode — IDE Mode or AHCI Mode (AHCI Mode by default)
USB Controller — Enabled or Disabled (Enabled by default)
DVMT/FIXED Memory — 128MB; 256MB; Maximum (256MB by default)
AC Recovery — Power On; Power Off; Last Power State (Power Off by default)
Remote Wake Up — Enabled or Disabled (Enabled by default)
Auto Power On — Enabled or Disabled (Disabled by default)
Auto Power On Date — 0 to 31 (15 by default)
Auto Power On Hour — 0 to 23 (12 by default)
Auto Power On Minute — 0 to 59 (30 by default)
Auto Power On second — 0 to 59 (30 by default)
Numlock Key — On or Off (On by default)
Keyboard Errors — Report or Do Not Report (Report by default)
Deleting the administrator password will delete system password. Hence, the administrator