Dell Inspiron One 2305 Service Manual page 39

Infrared Blaster Connector: Dell Inspiron One 2305/2310 Service Manual
Back to Contents Page
Infrared Blaster Connector
Dell™ Inspiron™ One 2305/2310 Service Manual
Removing the Infrared (IR) Blaster Connector
Replacing the Infrared (IR) Blaster Connector
WARNING: Before working inside your computer, read the safety information that shipped with your
computer. For additional safety best practices information, see the Regulatory Compliance Homepage at
www.dell.com/regulatory_compliance.
CAUTION: Only a certified service technician should perform repairs on your computer. Damage due to
servicing that is not authorized by Dell™ is not covered by your warranty.
CAUTION: To avoid electrostatic discharge, ground yourself by using a wrist grounding strap or by
periodically touching an unpainted metal surface (such as a connector on your computer).
Removing the Infrared (IR) Blaster Connector
1. Follow the instructions in
2. Remove the back cover (see
3. Follow the instructions from
4. Follow the instructions from
5. Remove the nut that secures the infrared (IR) blaster to the system-board shield.
6. Release the IR blaster connector from the slot on the system-board shield.
7. Lift the IR blaster connector along with its cable away from the system-board shield.
1 IR blaster connector
Replacing the Infrared (IR) Blaster Connector
file:///T|/htdocs/systems/InsOne2310/sr/sm/ir.htm[7/25/2012 10:24:52 AM]
Before You Begin.
Removing the Back Cover).
step 2 to step 5 in Removing the Front
step 4 to step 8 in Removing the System-Board
Stand.
Shield.
2 nut