Adjusting The Presser Foot Height - Brother S-6200A Instruction Manual

13. STANDARD ADJUSTMENTS

13-4. Adjusting the presser foot height

51
The standard height of the presser foot (1) is 6 mm when the
3893M
presser foot (1) is raised by means of the lifting lever (2).
1. Loosen the nut (3) of the adjustment screw (4), and then
2. Raise the lifting lever (2). The presser foot (1) will also
3. Remove the oil cap (5).
4. Loosen the bolt (6) and then move the presser bar (7) up
5. Tighten the bolt (6).
6. Replace the oil cap (5).
7. Adjust the presser foot pressure using the adjustment
* After adjusting, check that the needle moves down into the
Needle
center of the groove in the presser foot.
1257M
S-6200A
turn the adjustment screw (4) so that there is no pressure
applied to the presser foot.
rise.
or down until the presser foot (1) is at the standard height
of 6 mm.
screw (4), and then tighten the nut (3).