Table of Contents
Advertisement
Adjusting the height of the
presser foot
The standard height of the presser foot (1) is 6 mm
when the presser foot (1) is raised by means of the
lifting lever (2).
1
Loosen the nut (3), and then loosen the
adjustment screw (4) so that there is no pressure
applied to the presser foot.
2
Raise the presser foot (1) by using the lifting
lever (2).
3
Remove the rubber cap (5) from the face plate.
4
Loosen the bolt (6) and then move the presser
bar (7) up or down until the presser foot (1) is at
the standard height of 6 mm.
5
Tighten the bolt (6).
6
Install the rubber cap (5).
7
Adjust the presser foot pressure using the
presser adjustment screw (4), and then tighten
the nut (3).
NOTE
After adjusting, check that the needle moves down into
the center of the groove in the presser foot.
Page 61
Hide quick links:
Advertisement
Table of Contents
