Sewing Name Labels - Brother S-6200A Instruction Manual

7-5. Sewing name labels

1
Setting the number of name label stitches
2
3
4
5
<If using a solenoid-type presser lifter>
After the fixed stitches in E and F are sewn, the presser foot is also lifted automatically.
<Automatic thread trimming>
Press the thread trimming key to turn on the thread trimming function. Thread trimming is carried out
automatically after the second set of F stitches has been sewn.
<Automatic sewing>
When the AUTO key is pressed to turn on the automatic sewing function, the fixed stitches in E and F
are sewn respectively simply by depressing the treadle once without needing to depress it
continuously.
<Start and end backtack sewing>
The start backtack key and end backtack key can be pressed to turn on the backtack sewing
function.
If changing the number of start and end backtack stitches in A, B, C and D, press the name label
stitch key to turn off the name label function before making the change. (The ABCD display will
show the number of stitches and the settings can then be changed.)
0835M
After the set number of stitches in E (fixed stitches) have been sewn, the needle bar stops in
the position that has been set by the needle up/down key (refer to p.39).
After the set number of stitches in F (fixed stitches) have been sewn, the needle bar stops in
the position that has been set by the needle up/down key (refer to p.39).
Repeat steps 2 and 3 above.
Thread trimming is carried out.
7. USING THE G5A OPERATION PANEL (BASIC OPERATIONS)
From 0 to 1999 stitches can be set for the E and F stitch numbers.
S-6200A
4179M
Example:
2159M
2160M
36